Difference between revisions of "Common Questions"
From Typewriter Wiki
(Created page with "Others have also felt your pain. === Removing hair and dust (some crusted in) === A detailing brush with a small handheld vacuum that's used for computers can be effective a...") |
|||
| Line 1: | Line 1: | ||
| − | Others have | + | Others have felt your pain. |
=== Removing hair and dust (some crusted in) === | === Removing hair and dust (some crusted in) === | ||
| Line 6: | Line 6: | ||
An air compressor can send piece of your typewriter flying if they're not secure, so some prefer a low powered vacuum with a dust cup with filter. There are ones for cleaning electronics/keyboards that can serve this purpose. Others used canned air or low pressure compressors. | An air compressor can send piece of your typewriter flying if they're not secure, so some prefer a low powered vacuum with a dust cup with filter. There are ones for cleaning electronics/keyboards that can serve this purpose. Others used canned air or low pressure compressors. | ||
| + | |||
| + | === My ribbon vibrator (piece that holds ribbon) is stuck === | ||
| + | |||
| + | Could be gunked up or need to be re-formed. Definitely rule out all other potential causes before bending the metal. | ||
Revision as of 00:14, 17 September 2020
Others have felt your pain.
Removing hair and dust (some crusted in)
A detailing brush with a small handheld vacuum that's used for computers can be effective at removing hair and other debris. Other tools one might use are a dental pick, a paint brush, and pipe/straw cleaners (single use or reusable, hard and soft). Using tools can be more effective than canned air at times.
An air compressor can send piece of your typewriter flying if they're not secure, so some prefer a low powered vacuum with a dust cup with filter. There are ones for cleaning electronics/keyboards that can serve this purpose. Others used canned air or low pressure compressors.
My ribbon vibrator (piece that holds ribbon) is stuck
Could be gunked up or need to be re-formed. Definitely rule out all other potential causes before bending the metal.
